Hook Lift Main rails 6” x 2” x 1/4” steel tube
Cable Pull Main rails 6” x 2” x 3/16” steel tube
Cross members 3” x 3” x 1/8” steel tube on 24” centers
Walls, doors and fronts 12 GA steel plate
Vertical studs 3” x 3” x 1/8” steel tube on 48” centers
Floors 3/16” steel plate
Rear post 5” x 3” x 3/16” steel tube
Front rail 4” x 3” x 1/8” steel tube
Side rail 4” x 3” x 1/8” steel tube
Landing gear (wheel mount) 5” x 3” x 3/16” steel tube
Door frame 4” x 3” x 1/8” steel tube
Hinges ½” x 4” flat bar and 1-1/4” extra heavy pipe with 1-3/16” cold rolled pin
Outside floor to wall dirt skirts, 1/8” x 5” flat bar
Inside full length wall supports 1/8” x 6” flat bar on 60” walls and larger
Latch
SCS easy open design
Wheels
5” standard pipe with 1-1/4” extra heavy pipe hubs with 1-3/16” cold rolled shaft
All wheels have full length hubs for axle support and mount to the landing gear cross member with 1/2” steel plate
Welding
Inner and outer floor seams, front and rear wall seams and inside top rail seam are continuous welds
A–Frame 54” or 62”
Note: Body measured by floor length – add approximately 1ft for overall length
 Print Version...
Note: Subject to change without notice. Custom designs available on request. |
